The packaging material netting machine must be installed on a flat, clean indoor floor. For the convenience of operation and maintenance, the space left and right of the machine must be no less than 750mm wide. There must be sufficient entry and exit space before and after the machine. This article will introduce you to the requirements of the plate machine accessories.
When the platen machine is enabled, the packaging material net first checks whether the circulating pump works normally, whether the interfaces and pipes are leaking, and the packaging material net ensures that the gears of each component operate normally. After use, turn off the power and water, and use a cleaning bottle to rinse off the liquid crystal attached to the roller shaft and gear. The packaging material net uses water to rinse the rubber roller, remove the glue remaining on the rubber roller, and replenish the liquid in the refilling tank.
The thermal type plate-making machine adopts fine micro-computer control system, the packaging material net is used for flushing time, liquid medicine and drying temperature, circulating filtration, cleaning rubber roller, packaging material net, secondary glue washing, etc. A variety of modes, such as automatic control and random correction, are available for selection.
The packaging material net thermal plate-making machine is equipped with an emergency stop switch on the imported plate feeding table; it is convenient for handling problems under special circumstances and avoiding unnecessary troubles. Packaging material net drying overheating automatic protection device; chemical liquid level too low automatic replenishing device; mechanical transmission system closed protection device; packaging material network and safety warning signs of safety important parts of the machine and other products safety design.
Whether the parts of the plate machine are damaged due to transportation, if any, the packaging material network should immediately make a corresponding record and take pictures of the damaged part, and contact the carrier or supplier in time. A 4 minute tap water pipe should be connected to the equipment room. The height of the machine room drain should not be 150mm higher than the floor space of the platen machine. Packaging material net For easy cleaning of rollers and other parts, a properly sized pool should be provided in the equipment room.
Article source address: http://
Paper Holders,Stainless Steel Paper Holder,Towel Paper Holder
Fucheng Metals Production Co., Ltd. of Jiangmen City , https://www.fcmp.com