The paper feeding section of the machine can automatically count the number of stacks after the nail box is delivered. The stack height of the paper feed table is 900 mm. Because the interface of the robot machine is controlled, the operation is convenient, and the faulted part can be displayed so as to quickly eliminate the fault. When the machine appears to be blocked by a flat wire, or the flat wire is used up, an alarm message can be automatically displayed to prevent the occurrence of bad defects. The machine can generally set 10,000 or so cartons in 8 hours, which is basically suitable for the production of cartons.
The main function of automatic nail box machine
The machine paper table is driven by the hydraulic oil pump to raise and lower the cylinder. The upper and lower limit position switches can effectively prevent mechanical accidents caused by lifting and overtaking; the photoelectric device can control the automatic rise and maintain the normal paper feed height; The gap adopts electric adjustment device, suitable for various types of corrugated board with different thickness; PLC programmable controller system is stable and reliable, AC servo motor controls the board advance and stop, ensures the nail pitch is uniform and accurate; automatically counts the light eyes to the finished product Automatically count record output, and can be set to separate and send, with the end of the end of the operation; nail box machine's head is made of special steel refined, with a wearable and practical effect; machine electronic control system using a color touch screen, providing good The man-machine interface completes the automatic setting of the nail pitch, the setting or cancellation of reinforcement nails, and the troubleshooting.
Analysis of Common Faults of Stapler Machine
Stiffness or length of the nail has obvious errors
In the nail box, it will be found that when the flat yarn quality is not good, the feed line resistance is large, the feed reel spring is too loose or too tight, the feed reel fixing screw is loosened, the guide rail is deflected, the gear bite is skewed, and the head bottom mold is set When the position of the punch is not correct and the bottom mold has obvious wear, etc., there are prone to the above-mentioned failure phenomenon. In this regard, the solution is: the use of good quality, smooth surface plating of high-quality flat wire; check the various parts of the delivery line is not adjusted and cause jams; adjust the machine-related components to make the wire movement can be easily and comfortably; wear Serious counters take appropriate repair or replacement measures.
The main problem of the heading
When there is a staple in the stapler, it is often easy to affect the normal operation of the clutch. The side cover can be disassembled to take out the punch for cleaning and cleaning, and can be reinstalled after adding the lubricant. If the positioning of the head is not accurate When checking F3 fuses 34-35 (AC), F9 fuses 50-51 (DC), and brake coil resistance wire (15Ω), etc. are normal; if the upper shield photoelectric sensor switch is not activated, the sensor cannot The axis of the guide rail causes the paper not to enter the nail, and the sensing distance of the photoelectric switch can be adjusted. If the nail head has continuous nailing action, it is necessary to check whether the electric appliance is damaged.
Cardboard did not open after the tailgate
If the photoelectric sensor of the baffle is not normal, this fault condition is likely to occur. The photoelectric sensor device can be adjusted so that the sensing distance can be maintained properly to ensure that the paperboard can be normally operated after the baffle plate is fed.