Rat Ghrelin ELISA Kit
Rat Ghrelin ELISA Kit
(Used in serum, plasma, cell culture supernatant and other biological fluids)
principle
This experiment uses the double antibody sandwich ABC-ELISA method. Coated with anti-rat Ghrelin monoclonal antibody on the enzyme plate, the Ghrelin in the standard and the sample is combined with the monoclonal antibody, biotinylated anti-rat Ghrelin is added to form an immune complex connected to the plate, horseradish peroxid The enzyme-labeled Streptavidin is combined with biotin, the substrate working solution is added, and the final solution is added with sulfuric acid. The OD value is measured at 450nm. The Ghrelin concentration is directly proportional to the OD value. concentration.
Kit composition (stored at 2-8 ° C)
Coated Wells
96 wells
Enzyme Conjugate
12ml
10 × Sample Buffer
12ml
20 × concentrated washing solution (Wash Buffer)
50ml
Standards (Standards): 5ng / bottle
2 bottles
Substrate working solution (TMB Solution)
12ml
The first antibody working solution (Biotinylated Antibody)
12ml
Stop Solution (Stop Solution)
12ml
Prepare reagents and collect blood samples
1. Collect specimens: serum, plasma (EDTA, citrate, heparin anticoagulation), cell culture supernatant, tissue homogenate, etc. as soon as possible, stored at 2-8 ℃ for 48 hours; longer time must be frozen (-20 ℃ Or -70 ℃), avoid repeated freezing and thawing. Before the normal specimen is measured, use the specimen diluent to make a 1:10 dilution (take 20ul, add specimen diluent 180ul, dilute 10 times).
2. Preparation of standard solution: add 0.5ml of distilled water to mix well before use to make a 10ng / ml solution. Set 8 standard tubes, add 900ul of sample dilution in the first tube, and 500ul of sample dilution in the second to eighth tubes. Add 100 ul of standard solution of 10 ng / ml to the first tube and mix it. Then aspirate 500 ul with the sampler and move to the second tube. Repeat the dilution in this manner repeatedly, draw 500ul from the seventh tube and discard it. The eighth tube is a blank control.
3. The 10 × specimen dilution is diluted 1:10 with distilled water (example: 1ml concentrated dilution + 9ml distilled water).
4. Washing solution: 1:20 dilution with redistilled water (example: 1ml concentrated washing solution is added with 19ml of redistilled water)
Testing procedures
1. Add sample: add 100ul of standard or sample to be tested to each well, mix the reaction plate thoroughly and place at 37 ℃ for 120 minutes.
2. Wash the plate: wash the reaction plate 4-6 times with the washing solution, and print it on the filter paper.
3. Add 100ul of the first antibody working solution to each well. The reaction plate was mixed thoroughly and then placed at 37 ° C for 60 minutes.
4. Wash board: same as above.
5. Add 100ul of enzyme-labeled antibody working solution to each well. Place the reaction plate at 37 ° C for 30 minutes.
6. Wash board: same as above.
7. Add 100ul of substrate working solution to each well, and place in a dark place at 37 ℃ for 15 minutes.
8. Add 100ul of stop solution to each well and mix well.
9. Measure absorbance at 450nm with a microplate reader within 30 minutes.
Result calculation and judgment
1. All OD values ​​should be calculated after subtracting the blank value.
2. With the standard products 1000, 500, 250, 125, 62.5, 31.2, 15.6, 0 pg / ml as the abscissa, and the OD value as the ordinate, draw a graph on the graph paper and draw a standard curve.
3. Find the corresponding Ghrelin content on the graph according to the OD value of the sample, and then multiply it by the dilution factor.
Kit performance
1. Sensitivity: The smallest Ghrelin detection concentration is less than 10pg / ml.
2. Specificity: simultaneous detection of recombinant or natural rat Ghrelin. Does not cross-react with other cytokines in rats.
3. Repeatability: The coefficient of variation within the board and the board is less than 10%.
Precautions
1. The above standard holes and samples to be tested are recommended to be re-holes, and the standard curve should be made at the same time for each measurement.
2. The washing process is critical. Insufficient washing will lead to an increase in accuracy error and OD value.
3. After opening the slats, the remaining slats should be sealed again to keep the slats dry.
4. This kit should be stored in a 4oC refrigerator.
5. This kit is for scientific research only, not for clinical diagnosis!
A shave brush's price is usually determined more by its bristle load than any other factor, except for brushes with very exotic handles. The most expensive brushes often use exotic materials in the handle. The bristles are fixed together into a knot that is installed into the handle. The best quality brushes are hand knotted. Badger and boar brushes are the most commonly found animals used for shaving brush fibers. Badger species include the Eurasian badger and the hog badger.
Synthetic shave brushes, most often made using nylon bristles, are available in a range of prices and gradations in quality. Comparable to traditional shaving brushes, synthetic fiber brushes can quickly create a rich lather using relatively little shaving soap or cream. The synthetic fibers dry faster than natural hair and are less sensitive to everyday use.
Boar's hair brushes are relatively inexpensive, but can be of very high quality. A well-made boar brush will break in with use; the bristles begin to split at their tips, resulting in a brush that is very soft but has considerable backbone. Unlike badger hair and synthetic fibers, boar bristles absorb water, so the brush should be soaked before use.
Badger hair brushes come in a variety of grades, but there is not an industry standard that specifically defines grades of badger hair. Generally speaking, though, there are basic classifications that many manufacturers use to describe the quality of hair used in their brushes
Shaving Brush,Skincare Shaving,Shaving Brush Set,Shaving Brush Kits
SAMINA FORAM (SHENZHEN) CO., LIMITED. , https://www.saminamakeuptools.com